S8011 Series Normally Open 0-0.5 bar Natural Gas Manual Reset Solenoid Valve
Normally open 0–0.5 bar natural gas manual reset solenoid valve for building entries; works with gas detectors (230 V AC) or seismic sensors (12 V DC).
Manual reset solenoid valves are installed at the gas entry of buildings, workplaces, workshops and factories and shut off the gas on a signal from a gas leak detector or seismic sensor. After shut-off, the valve can only be reopened by resetting it by hand.
| Position | Normally open, manual reset |
|---|---|
| Number of ways | 2/2-way |
| Connection | DN50, DN65, DN80, DN100 |
| Orifice | 50 – 100 mm |
| Pressure | S8078: 0 – 6 bar · S8079: 0 – 0.5 bar |
| Coil voltage | 230, 220, 110, 24, 12 V AC; 24, 12 V DC |
| Coil protection | IP65, with connector |
| Diaphragm / seal | NBR |
| Tube / core | Brass, stainless steel |
| Use | Natural gas lines; controlled by gas alarm device (230/220 V AC coil) or earthquake device (12 V DC coil) |
Normally open 0–0.5 bar natural gas manual reset solenoid valve for building entries; works with gas detectors (230 V AC) or seismic sensors (12 V DC).
Normally open brass-body manually reset solenoid valve for natural gas, LPG and non-corrosive gases; 1/2"…3/4", 0…6 bar.
Normally closed brass-body solenoid valve for gases and liquids; G 1/8"–1/4", 1.8/2.5 mm orifice, 0…14 bar, -20…160°C.
Normally open brass-body manual reset solenoid valve for natural gas and LPG; 1/2"–3/4", 0–6 bar, IP65 and Ex-proof.