Pneumatic retrofit on a body-in-white welding line

Air leaks and clamp-related stoppages were reduced on a robotic body welding line; fault diagnosis now takes minutes.

Problem

On a robotic body-in-white line, 48 fixture stations holding the parts were running on individually piped valves and cylinders installed many years ago.

  • Air leaks: Worn fittings and long, oversized hose runs wasted a lot of compressed air; compressors were constantly loaded.
  • Unknown clamp position: A clamp that failed to close was only noticed when the robot faulted and the line stopped.
  • Weld spatter: Spatter sticking to piston rods quickly destroyed the seals.
  • Long troubleshooting: Finding the faulty valve or cylinder took the maintenance team a long time.
Solution

The line was first surveyed on site: an ultrasonic leak survey was carried out and air consumption was measured per station. The retrofit was then rolled out station by station during weekend shutdowns so production was not interrupted.

  • Valve islands: Scattered valves were replaced by fieldbus valve islands at each station; diagnostics go straight to the operator panel.
  • Sensor-equipped cylinders: Cylinders with magnetic pistons and position sensors confirm every clamp is open/closed before welding starts.
  • Welding-proof components: Cylinders with spatter-resistant scraper seals and protective covers were used.
  • Re-designed air supply: Hose runs were shortened and sized correctly; air preparation, soft-start and safety exhaust valves were added at each station inlet.
  • Air shut-off at standstill: Station air is cut automatically when the line goes idle.
Result
  • About 28% lower compressed-air consumption, with compressor load and energy cost falling accordingly.
  • About 40% fewer unplanned stoppages caused by clamps.
  • Fault location now takes minutes thanks to valve island diagnostics.
  • Valve and cylinder types were standardised, simplifying spare-parts stock.