90 kW hydraulic power unit for a rolling mill
A frequently failing unit in a hot rolling-mill environment was replaced with a cooled, energy-efficient design.
Problem
The hydraulic unit feeding the roll-adjustment and shear systems of the rolling mill kept dropping out because of the hot, dusty environment.
- Overheating: A fixed-displacement pump delivered full flow even when not needed, turning surplus energy into heat; oil temperature exceeded its limits.
- Viscosity loss and wear: Thinning hot oil accelerated wear in pumps and valves, while hardened seals leaked.
- Contamination: Mill scale and dust were getting into the tank and the oil.
- No early warning: Temperature, level and filter condition were not monitored, so faults were only noticed when the unit stopped.
Solution
- Variable-displacement pump: A pressure- and flow-controlled axial piston pump delivers only what the system needs, greatly reducing heat generated at idle.
- Dual-circuit cooling: Besides the water-oil heat exchanger in the main circuit, a separate filtration and cooling circuit keeps the oil clean and cool even when the machine is idle.
- Proportional control and accumulator: Proportional valves give precise, smooth roll adjustment; peak flow demand is covered by an accumulator.
- Heat-resistant materials: High-temperature seals and hoses, plus hose guards against scale spatter, were used; the tank breather is now filtered.
- Monitoring: Oil temperature, level and filter-clogging sensors are wired to the control system and raise an alarm before limits are reached.
Result
- Operating oil temperature dropped by about 18 °C and stays within a safe range.
- The variable-displacement pump noticeably reduced the unit's energy consumption.
- No unplanned stoppages caused by the unit since commissioning.
- With sensor monitoring, filter and oil changes are planned instead of waiting for a failure.